FWC-122-25
Datasheet
Key Features
- Supports TDD-LTE Band 41* 3GPP Release 12 Compliant
- Supports up to UE LTE Downlink Category 12/ Uplink Category 13 PHY Rate **
- Supports 4×4 MIMO with 40 MHz CA Maximum and DL 2×2 MIMO up to 80 MHz CA
- Supports DL 256QAM with DL 2×2 MIMO only (Contiguous and Non-Contiguous Bandwidth)
- Supports UL 2Tx (CDD / UL_CA/ UL_MIMO) Physical 2Tx & 4Rx in RF Front End
- Supports 1.8V and 3V SIM and USIM Card for LTE Mode
- Supports Dynamic Host Configuration Protocol
- Built-in Web Server for Web-Based Configuration
- Password Protected Access and Configuration
- Supports IEEE 802.3, IEEE 802.3u, 802.3ab (10/100/1000 Mbps )
- Supports 802.3at POE standard – Available on outdoor rated WAN port
- Supports NAT/Tunnel/Bridge/Router Mode Supports VPN Pass-Through
- IP67 Environmental Rating
* TDD Cat 12 with 4×4 + 40MHz carrier aggregation peak downlink throughput is around 440Mbps @ TDD Config 2 SSF 7 with 64QAM ; uplink throughput is around 30Mbps @ 20+20MHz TDD Config 2 SSF 7 with 64QAM
** TDD Cat 13 UL CA +64 QAM is around 30 Mbps f or uplink.
Specifications
FWC-122-25
| MECHANICAL, ENVIRONMENTAL & REGULATORY | FWC-122-25 | |
|---|---|---|
|
Dimension (L x W x H) |
9.8” x 9.8” x 2.2” (250 x 250 x 55mm) |
|
|
Weight |
3.5 lbs (1.6 kg) |
|
|
PoE |
802.3at |
|
|
Power |
Input: Universal range 100~240V AC ; Output: 56 VDC |
|
|
Reset/Reboot Button |
Tactile Switch (inside box) |
|
|
Operating Humidity |
5% to 95% |
|
|
Storage Humidity |
5% to 95% |
|
|
Operational Temperature |
-40°F to 131°F (-40°C to 55°C) |
|
|
Storage Temperature |
-40°F to 158°F (-40°C to 70°C) |
|
|
FCC |
FCC Certified |
|
|
Safety |
IEC 60950-22:2016, IEC 62368-1:2014 compliant |
|
|
RF Exposure |
Meets 47 CFR FCC Part 2.1091 |
|
| NETWORKING & OAM | FWC-122-25 | |
|---|---|---|
|
LTE BB ASIC |
GDM7243A (GCT Semiconductor) |
|
|
LTE RF ASIC |
GRF7243A (GCT Semiconductor) |
|
|
Ethernet LAN Port |
One RJ-45 Port 10/100/1000 Auto-Sensing, Auto-MDX |
|
|
LED Indicators |
Signal Strength / LAN / SIM |
|
|
SIM Function |
1.8V, 3V SIM and USIM card |
|
|
PIN/PUK Code |
Yes (Ready with chipset) |
|
|
Stack |
IPv4, IPv6, Dual |
|
|
NAT/Dynamic NAT |
Yes |
|
|
Router Mode |
Yes |
|
|
Bridge Mode |
Yes |
|
|
Tunnel Mode |
GRE, L2TP, IPsec, PPTP (Available per request) |
|
|
DCHP Server in LAN |
Yes (For NAT mode, support 253 clients max.) |
|
|
DNS Relay |
Yes |
|
|
DDNS Client |
Yes |
|
|
VPN Pass-Through – IPSec/PPTP/L2TP |
Yes |
|
|
UPNP |
Yes |
|
|
HTTP(s) Server |
Yes |
|
|
ALG Support (FTP/SIP/...) |
Yes |
|
|
Networking Debug/Testing |
IPerf, Ping, Traceroute |
|
| RADIO SPECIFICATION | FWC-122-25 | |
|---|---|---|
|
Peak DL Throughput |
440 Mbps (4x4 + 40 MHz CA, TDD Config 2-7) |
|
|
Peak UL Throughput |
30 Mbps (TDD Config 2-7 with 64 QAM) |
|
|
Carrier Aggregation |
2CC up to 20 MHz each |
|
|
Frequency Band |
TDD LTE Band 41 |
|
|
DL Carrier Aggregation Bandwidth |
80 MHz max. |
|
|
UL Carrier Aggregation Bandwidth |
40 MHz max. with 2CC |
|
|
UL 2Tx Diversity |
26 dBm |
|
|
UL 2Tx CA |
23 dBm |
|
|
UL 2Tx MIMO |
23 dBm |
|
|
Tx Power Dynamic Range |
63 dB |
|
|
Receiver Sensitivity (@ 20 MHz) |
-96 dBm |
|
|
Channel Bandwidth |
10, 20 MHz |
|
|
DL Carrier Aggregation Matrix |
DL MIMO 2x2 – Intra, Contiguous & Non-Contiguous DL MIMO 4x4 – Intra Band Only |
|
|
DL Modulation |
4x4 MIMO with 64 QAM Max. 2x2 MIMO with 256 QAM Max. |
|
|
UL Modulation |
Max. 64 QAM |
|
|
LTE Compliance |
3GPP Release 12 |
|
|
Antenna Peak Gain (Single) |
12.5 dBi (4 antennas) |
|
| DEVICE MANAGEMENT & SECURITY | FWC-122-25 | |
|---|---|---|
|
WEB |
Yes |
|
|
SNMP |
Ready for IoT |
|
|
TR-069 |
Ready for IoT |
|
|
FOTA Upgrade |
Yes |
|
|
System Log/Diagnostic |
Yes (Chipset embedded tool) |
|
|
Username/Password Configuration |
Yes |
|
|
L2/L3 Firewall |
Basic Firewall/Port Forwarding/Port Trigger/DMZ/Remote WAN Ping/Remote Web Access Control |
|
|
Time Zone Configuration |
Yes |
|
|
Dual Firmware |
Yes (Switchable) |
|
|
Firmware Verification |
Yes (Use digital signal to verify installed software) |
|
© All rights reserved BLiNQ Networks