FWC-145IN-35

Datasheet

Save as PDF

Key Features

  • Supports TDD-LTE Mode Band 42/43 & 48* Supports 3GPP Release 12 Compliant
  • Supports up to UE LTE Downlink Category 12/ Uplink Category 13 PHY Rate **
  • Supports 4×4 MIMO with 40 MHz CA Maximum
  • Supports DL 256QAM with DL 2×2 MIMO only up to 4 Carrier Aggregation
  • Supports UL 2Tx (CDD / UL_CA/ UL_MIMO) Physical 2Tx & 8Rx in RF Front End
  • Supports 1.8V and 3V SIM and USIM Card for LTE Mode
  • Supports Dynamic Host Configuration Protocol
  • Built-in Web Server for Web-Based Configuration
  • Password Protected Access and Configuration
  • Supports IEEE 802.3, IEEE 802.3u, 802.3ab (10/100/1000 Mbps )
  • Supports up to 2 RJ-45 Giga Ethernet Port
  • Supports NAT/Tunnel/Bridge/Router Mode
  • Supports VPN Pass-Through and End Point
  • Supports 802.11 b/g/n (2 x 2)
  • Wi-Fi Technology
  • Supports 802.11 ac Wave 2 (2 x 2) Wi-Fi Technology

* B48 under FCC Part 96 requirement. No inter-band support for B42/43 + B48

** TDD Cat 12 with 4×4 + 40MHz carrier aggregation peak downlink throughput is around 440Mbps @ TDD Config 2 SSF 7 with 64QAM ; uplink throughput is around 30Mbps @ 20+20MHz TDD Config 2 SSF 7 with 64QAM

Specifications

FWC-145IN-35

MECHANICAL, ENVIRONMENTAL & REGULATORY FWC-145IN-35
Dimension (H x D)
7.9” x 5.3” (200 mm x 134 mm)
Weight
1.1 lbs (0.5 kg)
PoE
802.3at
Power
Input: Universal range 100~240V AC
Output: 12V/1.5A DC
Reset/Reboot Button
Tactile Switch (inside box)
Operating Humidity
0% to 95%
Storage Humidity
0% to 95%
Operational Temperature
32°F to 104°F (0°C to 40°C)
Storage Temperature
-4°F to 140°F (-20°C to 60°C)
RF
EN 301 908-1 V11.1.1; EN 301 908-13 V11.1.1 (Part 96)
Wi-Fi 2.4 GHz
EN 300 325 V2.1.1 (Part 15C)
Wi-Fi 5 GHz
EN 301 893 V2.1.1
Safety
IEC 60950-1/EN 60950-1
EMC
Draft EN 301489-1 V2.2.0 ; Draft EN 301489-17 V3.2.0
RF Exposure
EN 50385:2002 ; EN 62311:2008
CBSD Category
CBSD Cat A
NETWORKING & OAM FWC-145IN-35
LTE BB ASIC
GDM7243A (GCT Semiconductor)
LTE RF ASIC
GRF7243A (GCT Semiconductor)
Ethernet LAN Ports
2 x RJ-45 Port ; 10/100/1000 Auto-Sensing, Auto-MDX
11b/g/n Wi-Fi SoC
RTL8192ES (Realtek)
11ac Wi-Fi SoC
RTL8812BEH (Realtek)
LED Indicators
Signal Strength / LAN / Wi-Fi / SIM / Power
SIM Function
1.8V, 3V SIM and USIM card
PIN/PUK Code
Yes (Ready with chipset)
Stack
IPv4, IPv6, Dual
NAT/Dynamic NAT
Yes
Router Mode
Yes
Bridge Mode
Yes
Tunnel Mode
GRE, L2TP, IPsec, PPTP (Available per request)
DCHP Server in LAN
Yes (253 Clients)
DNS Relay
Yes
DDNS Client
Yes
VPN Pass-Through – IPSec/PPTP/L2TP
Yes
UPNP
Yes
HTTP(s) Server
Yes
ALG Support (FTP/SIP/...)
Yes
Networking Debug/Testing
IPerf, Ping, Traceroute
RADIO SPECIFICATION FWC-145IN-35
Peak Throughput
DL 440 Mbps (Config 2-7); UL 30Mbps (Config 2-7)
Carrier Aggregation
DL 4CC up to 20 MHz each (w. DL 2x2)
DL 2CC up to 20MHz each (w. DL 4x4)
DL 1CC up to 20MHz each (w. DL 4x8)
UL Maximum 40MHz with 2CC
Frequency Band
TDD LTE Bands 42, 43, 48
DL Carrier Aggregation Bandwidth
80 MHz max.
UL Carrier Aggregation Bandwidth
40 MHz max. with 2CC
UL 2Tx Diversity
23 dBm
UL 2Tx CA
23 dBm
UL 2Tx MIMO
23 dBm
Tx Power Dynamic Range
63 dB
Receiver Sensitivity (@ 20 MHz)
-96 dBm
Channel Bandwidth
10, 20 MHz
DL Carrier Aggregation Matrix
DL MIMO 2x2 / 4x4 / 8x4
UL 1x2 (with diversity); UL 1x2 CA; UL 2x2
MIMO
DL MIMO 2x2 / 4x4 / 8x4
UL 1x2 (with diversity); UL 1x2 CA; UL 2x2
LTE Compliance
3GPP Release 12
USER INTERFACE & SECURITY FWC-145IN-35
WEB
Yes
SNMP
Yes
TR-069
Ready for IoT
TR-0143
Ready for IoT
FOTA Upgrade
Yes
System Log/Diagnostic
Yes (Chipset embedded tool)
Username/Password Configuration
Yes
L2/L3 Firewall
Basic Firewall/Port Forwarding/Port Trigger/DMZ/Remote WAN Ping/ Remote Web Access Control
Time Zone Configuration
Yes
Firmware
Dual Image (Switchable)
Firmware Verification
Yes (Use digital signal to verify installed software)
Save as PDF

Your Network. Our Solutions.

Fixed Wireless 5G and LTE equipment manufacturers